Starship SN8 pressing to Static Fire and nosecone installation firsts

The stage is set for a milestone Static Fire test for Starship SN8 during a… The post Starship SN8 pressing to Static Fire and nosecone installation firsts appeared first on NASASpaceFlight.com.

Starship SN8 pressing to Static Fire and nosecone installation firsts

The stage is set for a milestone Static Fire test for Starship SN8 during a lengthy window that extends into Monday morning. Aiming to cultivate in the first-ever firing of three Raptors simultaneously, passing the milestone will allow for the nosecone’s installation – with a header tank – for a repeat test in around a week.

SN8 Static Fire:

Sunday night’s test follows an aborted attempt earlier in the week.

Although SpaceX has conducted numerous Static Fire tests with its Starship prototypes, this is the first time three Raptors will have been fired together. This includes at SpaceX’s test center in McGregor, Texas – where Raptors are test fired individually.

The test path has been refined over the evolution of Starship, with two objectives within a few hours of each other set to take place.

Once the vehicle has been prop-loaded, controllers will conduct a preburner test. A preburner is essentially a small engine that powers a turbopump. Each Raptor engine has two, one for the liquid oxygen oxidizer and one for the methane fuel.

Providing the data from this objective is deemed acceptable; recycling of the vehicle will prepare for the Static Fire test that will utilize Raptors SN30, 32, and 39.

Starship Prototypes Updates
  • SpaceX Super Heavy/Starship Section
  • L2 SpaceX Section
  • Click here to Join L2
  • Although SpaceX does not provide any running commentary or official info into Starship testing, the go to proceed towards the firing of the Raptors will be known via Mary (@bocachicagal) hearing a police siren.

    Mary, and the other local residents of Boca Chica Village, are provided a heads up of testing, including the notification of a police siren with 10 minutes to the Static Fire.

    Not least because this is a unique test for Starship, all three engines’ actual firing will still require a major data check into the system’s health. SpaceX could recycle the test for a second firing attempt within the long window, or potentially in the days to come.

    If the data is good, SN8 will next expect to receive the nosecone that has finally been identified.

    SpaceX Boca Chica has its own “Noseconeland” at the Production Facility, with numerous nosecones have been seen inside and outside the buildings, including a mated pathfinder nosecone in the Windbreak Facility.

    This past week has seen the structural test article removed from the Windbreak, while a few other nosecones were dismantled.

    This set the stage for SN8’s nosecone to confirm its destination as it was rolled out of the Big Tent facility and moved into the Windbreak to install its aero surfaces.

    On Sunday, the five-ring section – which the nosecone will sit on – was moved into position near the Windbreak as a prelude to a full nosecone mating.

    Dependant on SpaceX being happy with the first Static Fire test, the nosecone will be transported to the Launch Site and prepared for mating with SN8.

    Once mating operations have been completed, preparations for a second Static Fire test are expected, this time teams will be testing the three Raptors’ firing while pulling Liquid Oxygen from the header tank housed inside the nosecone.

    Another data review will then take place, this time to approve the Starship SN8 vehicle for the ambitious 50,000 feet test launch and landing attempt.

    SN9 Onwards:

    SN8’s test holds a high degree of risk for the vehicle. As such, SpaceX is taking appropriate mitigations to avoid impacts on the overall Starship test path.

    That mitigation comes in the form of additional Starships ready to enter the fray within days of being required.

    Starship SN9 is now fully stacked inside the Mid Bay and has a new neighbor, with SN10 now undergoing the business end of its stacking operations.

    This work is ongoing while additional Starship sections are being staged, with parts up to at least SN14 spotted over recent days.

    Simultaneously, an array of sections for a Super Heavy booster are waiting for the clearance to enter the High Bay for the stacking. They will form the first prototype vehicle, which is expected to conduct a 150-meter test hop on two Raptors.

    Work on the High Bay is complete from a structural standpoint, with workers now concentrating on preparing the building for the installation of the gantry crane that will undertake the work of stacking the sections on the tall booster.

    Most photos via Mary (@bocachicagal)

    **Support NSF’s youtube channel by subscribing and/or joining here**

    Cool gear and the ability to support our content: https://www.nasaspaceflight.com/shop/

    Texas Tank Watchers Shirt

     

    The post Starship SN8 pressing to Static Fire and nosecone installation firsts appeared first on NASASpaceFlight.com.

    Source : NASA More